• 大家都在搜: 不锈钢酒店装饰玻璃空透隔断 不锈钢金属工程玄关走道屏风 不锈钢酒店装饰中式屏风 不锈钢金属工程不锈钢橱柜 不锈钢花纹屏风镀钛
  • 18763996167


  • 全国咨询热线
四川福彩网
服务热线
18763996167
座机:0531-88275278 
邮箱: 279546205@qq.com
地址:山东省济南市天桥区大桥街道办事处倪家村136号
当前位置:四川福彩网-新闻资讯>常见问题>不锈钢仿古做旧工艺怎么做?

不锈钢仿古做旧工艺怎么做?

来源:http://www.719gcxzh.cn 日期:2020-07-07 发布人:shenghu
  不锈钢表面仿古铜效果,做旧是怎么做出来的呢,下面给大家简单的介绍下,让大家有个简单的了解:
  How is the antique copper effect on the surface of stainless steel? Let's give you a brief introduction to let you have a simple understanding:
  不锈钢仿古做旧有多种方法:其一是电镀,然后药水染色做成古铜色,这种工艺复杂成本昂贵,处理价格大概1平米在250--300元;虽然刚做好膜层牢固,但时间久了会氧化长铜锈绿穿孔,不环保;其二是在其表面喷涂铜粉漆再覆上一层格里斯油漆,再手工拉丝,其工艺比较粗糙,不上档次;处理价格1平米约80-100元;其三是我要介绍的药水氧化仿古铜工艺,该工艺为浸泡上色后处理,膜层牢固色泽逼真度为90%左右,价格约120-150元1平米。该做旧仿古如下:
  There are many ways to imitate the ancients of stainless steel sculptures: one is electroplating, and then the liquid medicine is dyed to make the ancient copper color. This process is complex and expensive, and the treatment price is about 250-300 yuan per square meter. Although the film is just made firmly, it will oxidize long rust green perforation after a long time, which is not environmentally friendly; the other is to spray copper powder paint on its surface, and then apply a layer of Gris paint, and then draw wire manually The technology is relatively rough, not up to grade; the treatment price is about 80-100 yuan per square meter; the third is the process of antique copper oxidation by liquid medicine, which is soaking and coloring, and the film is firm, the color fidelity is about 90%, and the price is about 120-150 yuan per square meter. This is as follows:
  1:不锈钢表面打磨(百洁布,砂纸)或盐酸活化。
                                                                  不锈钢金属工程
  1: Stainless steel surface grinding (cleaning cloth, sandpaper) or hydrochloric acid activation.
  2:用稀释后的不锈钢专用发黑药水(稀释比例:药剂:水=1:3)浸泡或者刷涂(在药水中)。
  2: Soak or brush with diluted stainless steel blackening solution (dilution ratio: reagent: water = 1:3).
  3:发黑后取出迅速放入清水中拉丝,拉丝过程中根据自己所需要的深浅颜色而控制拉丝手法的力度。
  3: After blackening, take it out and quickly put it into water for drawing. In the process of drawing, control the strength of drawing technique according to the depth and light color you need.
  4:然后再次用流动的干净自来水冲洗,晾干或者抹干。
  4: Then rinse again with clean running water, air dry or wipe dry.
  5:待晾干后罩一层氟碳仿古着色剂,(仿古铜着色剂是由氟碳清漆不同颜色的油性色精等成分调和而成)
  5: After drying, cover with a layer of fluorocarbon antique colorant (antique copper colorant is made of fluorocarbon varnish with different colors of oily colorants and other ingredients)
  6:层仿古着色剂干后再覆盖一层氟碳清漆。牢固效果更出色。
  6: The first layer of antique colorant is dried and then covered with a layer of fluorocarbon varnish. Stronger effect.
  7:注意事项:操作过程中必须做好防护措施(塑料手套,口罩)
  7: Precautions: protective measures must be taken during operation (plastic gloves, masks)
分享到:QQ空间新浪微博腾讯微博人人网微信